MagVISE Magnetic Workholding Blocks

Custom workholding without the “custom” cost

magnetic workholding

Click on the photo above to watch a short movie showing MagVISE magnetic work holding blocks in action.

Quickly load your workpiece

Use EZ-Lift lifting magnets together with the MagVISE magnetic workholding system to significantly reduce your load/unload and workpiece set-up times.

Machine all 5-sides

It’s easy to perform complex 5-sided machining using the MagVISE. You can even machine on 5 sides while holding a large number of workpieces using an array of MagVISE blocks.

The machinable soft jaws permit workpiece nesting for improved accuracy over other workholding systems. Also, you can machine right through the part without affecting the workholding.

Custom workholding fast

Use a MagVISE array to easily create custom magnetic workholding for large jobs and/or multiple workpieces. You can even hold a variety of different size and shaped workpieces all with one set-up.

Model
L x W x H
Min. Workpiece Thickness
Max. Force
ECB-050CN
5" x 3" x 3"
0.4"
1,100 lbs.
ECB-075CN
6.8" x 3" x 3"
0.4"
1,650 lbs.
ECB-120CN
7.3" x 4.2" x 4.2"
0.6"
2,640 lbs.
ECB-210CBN
9.2" x 5.2" x 5.3"
0.8"
4,620 lbs.
Additional machinable soft jaws are in stock if needed.

Note: Holding power is dependant upon workpiece size. ECB Magnetic Workholding Blocks are not for use with non-ferrous material, such as brass, aluminum, stainless steel, etc., or thin workpieces.

More about Magnetic Workholding

 

 

  • powerful magnetic workholding
  • FASTEST - load and unload
  • reduce set-up times
  • machine 5-sides easily
  • machinable soft jaws
  • modular system grows with you
  • no workpiece distortion
  • better accuracy and repeatability
  • use on pallet or machine bed
  • maintenance free

Switch-Connect Modular Units

By combining ECB Blocks you can quickly create custom workholding to fit a wide variety of workpiece sizes.

ON/OFF switch

Switch positively engages magnets with a simple turn of the wrench.

 

 


Stop plates are included to help align small parts and machine them more accurately

Hardened to HRC 55

18 hardened points keep top and bottom surfaces parallel.

magnetic workholding diagram

Different size MagVISE Blocks